How do you check a motor relay?

How do you test a motor relay?

Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.

How do I know if my blower motor relay is bad?

If you have a faulty blower motor, you may experience low airflow from the vents, even when the fan is on high. There will be no air coming from the vents if your fan isn’t working due to a bad blower motor resistor.

Can a relay cause a car not to start?

Car not starting: Another symptom of a faulty ignition relay is a no power condition. If the relay fails it will cut off power to fuel pump and ignition system, which will result in a no power, and therefore no start condition.

How long does a relay last?

Relays have a limited lifetime, but they are reliable in benign environments. 50,000-100,000 operations are usually at full rated load. Up to many millions of operations with a negligible load will experience an increase in life at lighter loads.

What causes a relay to fail?

In fact, the life of a relay is essentially determined by the life of its contacts. Degradation of contacts is caused from high in-rush currents, high- sustained currents, and from high voltage spikes. … Relays can also fail due to poor contact alignment and open coils.

THIS IS IMPORTANT:  What should I do if my transmission is going bad?

What happens when blower motor resistor goes bad?

If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.

Is there a fuse for the blower motor?

Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.

What can cause a blower motor to stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely.